Hi Rob
Changing to "Image" plus the increasing in the brightness to 1.2 brightened
the output.
Thanks for the tip.
Thanks
Ramesh
-----Original Message-----
From: Rob Geraghty [mailto:harper@wordweb.com]
Sent: Thursday, June 28, 2001 4:35 PM
To: filmscanners@halftone.co.uk
Subject: filmscanners: RE: filmscanners: Dark scans
Ramesh wrote:
>This is the first time I am scanning SLIDE:-)
Adjust the brightness. It defaults to 1.0 which is fine for negs but for
slides you probably need 1.2 to 1.4 depending on the density. Give it a
try. If you push it too far you'll get a lot of scanner noise. Don't worry
too much about the preview - look at a final scan after adjusting the
brightness.
Rob
Rob Geraghty harper@wordweb.com
