[filmscanners] RE: VueScan Negative Colour Balance Problems

["Conor Twomey" <conor.twomey@norkom.com>]

Tony wrote...

> Are you locking down the exposure and orange mask as described in the
> Advanced Workflow section of the manual? That is critical to getting good
> colour since the film data curves only operate after the mask has been
> removed.

Tony,

I am not doing that at present but I will give that a try over the next day
or so and get back to you.

Thank you.

Regards,
Conor.



The information contained in this e-mail transmission is confidential
and may be privileged. It is intended only for the addressee(s) stated
above.  If you are not an addressee, any use, dissemination, distribution,
publication, or copying of the information contained in this e-mail is
strictly prohibited. If you have received this e-mail in error, please
immediately notify our IT Department by telephone at 353-1-6769333
or e-mail internal.support@norkom.com and delete the e-mail from your
system.

----------------------------------------------------------------------------------------
Unsubscribe by mail to listserver@halftone.co.uk, with 'unsubscribe 
filmscanners'
or 'unsubscribe filmscanners_digest' (as appropriate) in the message title or 
body