[filmscanners] RE: Which SCSI Card for SS4000

["Kapetanakis, Constantine" <KAPETAC@polaroid.com>]

The ss4000 does have a SCSI termination switch.

-----Original Message-----
From: Austin Franklin [mailto:darkroom@ix.netcom.com]
Sent: Monday, September 09, 2002 4:24 PM
To: KAPETAC@polaroid.com
Subject: [filmscanners] RE: Which SCSI Card for SS4000


Hi Tom,

Possibly termination?  I don't remember, but is that device permanently
terminated, or is there a switch to enable internal termination?  If you
don't use the internal termination, and it's the last device in the SCSI
chain, you do have to provide a terminator either in-line where the cable
attaches to the unit, or on the "other" port.  It typically is best to use
the internal termination, since it's active termination, which is better.

Regards,

Austin

> My instructions indicated that but since it didn't work with the 25pin
> connector and did work with the SCSI 1 I thought that there was a type in
> the instructions.  Both cables were okay so I don't know what the problem
> might be.
>
> -----Original Message-----
> From: filmscanners_owner@halftone.co.uk
> [mailto:filmscanners_owner@halftone.co.uk]On Behalf Of Austin Franklin
> Sent: Monday, September 09, 2002 3:33 PM
> To: TMaugham@yahoo.com
> Subject: [filmscanners] RE: Which SCSI Card for SS4000
>
>
> Tom,
>
> > The input is a SCSI 1 cable (50 pin) the output (to another SCSI
> > device) is
> > 25 pin.
>
> I believe either can be used to connect to the SCSI card.
>
> Austin

----------------------------------------------------------------------------
------------
Unsubscribe by mail to listserver@halftone.co.uk, with 'unsubscribe
filmscanners'
or 'unsubscribe filmscanners_digest' (as appropriate) in the message title
or body

----------------------------------------------------------------------------------------
Unsubscribe by mail to listserver@halftone.co.uk, with 'unsubscribe 
filmscanners'
or 'unsubscribe filmscanners_digest' (as appropriate) in the message title or 
body